Table of contents
Installing the splinktegrated
In this section we will finish installing the splinktegrated into the case.
The screenshots and pictures show installation on different keyboards. Installation is the same on all keyboards.
Identifying the 3d print version
Depending on your kit version, there are two different 3d printed options.
- “USB Adapter” version
- “Audio jack” version

Depending on which version you got, follow the steps in either “Audio jack” or “USB Adapter” versions below.
Installation - Audio Jack version
The two sides are the same, just mirrored. We will show one.
For the following step, please prepare:
- keyboard assembly (x2)
- M4 screw (x4)

Seat the controller in the case and fasten it with two screws. Then solder the remaining pins of the audio jack - you already tacked the 5V pin so you could align it in the case.
Do the same on the other side.
Installation - USB Adapter version
The two sides are the same, just mirrored. We will show one.

For the following step, please prepare:
- keyboard assembly (x2)
- M4 screw (x4)
- 3d printed adapters

- Slide the splinktegrated into the adapter
- Slide the 3d printed adapter + splinktegrated assembly onto the case
- Fasten the assembly with two screws
- Solder the remaining pins of the audio jack - you already tacked the 5V pin so you could align it in the case
Do the same on the other side.
Installing the plates
If you have tents, skip to the next section “Installing the tents”.
Screws

For the following step, please prepare:
- keyboard assembly (x2)
- M4 screw (x8)
- plates (x2)
Secure the plates on the keyboard using the screws:

Anti-slip pads

For the following step, please prepare:
- anti-slip pads (x10)
Install the anti-slip pads:

Installing the tents
This step is optional, if you have tents.
Screws

For the following step, please prepare:
- keyboard assembly (x2)
- M4 screw (x8)
- plates (x2)
- tents (x2)
Secure the plates on the keyboard using one screw at the bottom:

Install the tents with the rest of the screws: 
Anti-slip pads

For the following step, please prepare:
- anti-slip pads (x10)
Install the anti-slip pads:
